Check (+) coil is 12V when ignition on

Remove (+) (-) from coil, should be ~3.2 ohms (no ballast)

Order new rotor - should be the more expensive red one
	(rotor can go bad and short the spark down to the distributor)

Check spark from coil either through spark plug or just take
	wire off of center of distributor

Can also take ignitor/distributor off (-) of coil, setup spark
	test and then ground and release the coil (-), should spark if coil good

Crane XR-700 ignition more reliable than Pertronix according to Greg Solow
	Crane has 2 yr warranty via Moss, Pertronix has 2.5 yr warranty

Distributor is DM2P4 (40480A) - not the replacement 25D4, actually

Pertronix LU-149
	Or LU-241LSN12????
	Or LU-241LS??

Cheaper option:  Accuspark?